![]() ![]() The angle of slope The HM303-6 has a built-in electronic Component Tester is determined by the resistance of the resistor under test. This can be The internal triggering is disconnected by depressing the TRIG. In order to avoid ground loops, use a mode can exceed an angle of 3.Īgain the correct slope setting is critical, because the external trigger signal may not have the same polarity or pulse edge as the test signal. Two identical probes should be used for two oscilloscope amplifiers of the HM303-6 in the X-Y both vertical inputs. The probes (therefore good pulse transmission performance) the following mentioned have a HF-calibration in addition to low frequency numerical relationship between rise time tr (in ns) and bandwidth calibration adjustment. With the above listed exceptions HAMEG 10:1 probes can be used for DC measurements up to 600V or AC voltages (with a mean value of zero volt) of 1200Vpp. The measuring circuits are considered not connected to the mains if a suitable isolation transformer ful. In case of complaints please contact the dealer who supplied your HAMEG product. Then the handle locking knobs must be simultaneously pulled outwards and STOP rotated to the required position. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |